Critical Environment Technologies PDC Series Especificaciones Pagina 8
- Pagina / 8
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
8
3.1 WIRING ANALOG OUTPUT MODULE, CONT’D…..
Outgoing Wiring
Connect two wires from remote display device to one or more of the analog output
terminal strips. These 2-position terminal strips are located (all together) along the top
edge of the circuit board. These terminal strips are clearly marked “+” and “-” as well
as by channel number. Eg. “CH1”. IMPORTANT: OBSERVE POLARITY. IF POLAR-
ITY IS INCORRECT, THE REMOTE DISPLAY DEVICE WILL NOT COMPLETE THE
SIGNAL LOOP AND A SIGNAL WILL NOT BE OBSERVED.
NOTE-1: DO NOT UTILIZE SOLID-CORE WIRE FOR CONNECTION TO ANY
TERMINAL STRIPS SOLDERED ONTO CIRCUIT BOARDS.
NOTE-2: FOR VISUAL CONFIRMATION, REFERENCE THE PHOTO OF THE
ANALOG OUTPUT MODULE CIRCUIT BOARD ON THE FOLLOWING PAGE.
9
4.0 ANALOG OUTPUT MODULE CIRCUIT BOARD PHOTO
COM B A 24V COM B A 24V 24VAC/DC
REMOTE
POWER
INCOMING
4-20 mA OUTPUT WIRE TERMINALS
4-20 mA “OPEN LOOP” LEDs
Relacionado con productos y manuales para No Critical Environment Technologies PDC Series
(16 paginas)Clay Paky ALPHA BEAM 700 (C61360) Handbücher
Bedienungsanleitungen und Benutzerhandbücher für Beleuchtung Clay Paky ALPHA BEAM 700 (C61360).
Wir stellen 4 PDF-Handbücher Clay Paky ALPHA BEAM 700 (C61360) zum kostenlosen herunterladen nach Dokumenttypen zur Verfügung Bedienungsanleitung
Comentarios a estos manuales